Technical Tip: FortiManager update information from FortiGuard using FDQN only

[WinterSnowYap]

Description	This article describes how to configure FortiManager to update information from FortiGuard using FDQN only.
Scope	FortiManager.
Solution	Below is the scenario: At FortiManager, use the below CLI command to check if FortiManager is currently using the IP address or FDQN to get information from FortiGuard: diag fmupdate view-serverlist fds At FortiManager, use the below CLI command to change FortiManager using FDQN only to get information from FortiGuard: config fmupdate fds-setting     set fortiguard-anycast enable end To revert the change, use the below CLI command: config fmupdate fds-setting     set fortiguard-anycast disable end