Troubleshooting Tip: Integrate Interface fails with 'firewall.policy does not support the target object's type as a replacement' error

[hbac]

Description	This article describes an issue when Integrate Interface feature fails to integrate a physical interface (port1) to an SD-WAN zone (virtual-wan-link) with the following error messages:
Scope	FortiGate.
Solution	This issue occurrs when SD-WAN is disabled. The SD-WAN zone (virtual-wan-link) is shown in grey.  To resolve the issue, enable SDWAN in the CLI with the following commands:  config system sdwan      set status enable  end  After that, the SD-WAN zone (virtual-wan-link) will be shown in red and Integrate Interface will work.  Related articles:  Troubleshooting Tip: 'An error occurred when attempting to change this reference (system.zone), this... Technical Tip: How to migrate a referenced interface Technical Tip: How to add the interface in SD-WAN member without deleting references Technical Tip: Moving an Interface that has existing references to SD-WAN zone using Integrate Inter...