FortiGate Next Generation Firewall utilizes purpose-built security processors and threat intelligence security services from FortiGuard labs to deliver top-rated protection and high performance, including encrypted traffic.
This article describes the ability to use SD-WAN zones as interface entries within Central SNAT configuration. The feature is available starting from FortiOS version 7.6.1. This enhancement improves policy flexibility and routing consistency in SD-WAN-enabled environments.
Scope
FortiGate devices running FortiOS v7.6.1 and later. Applies to Central SNAT, Local-In, DoS, TTL, and multicast policies referencing SD-WAN zones.
Solution
Use Case.
Previously, Central SNAT policies only supported specifying physical interfaces. Beginning with FortiOS v7.6.1, SD-WAN zones can be used as destination interfaces in Central SNAT policies. This simplifies NAT rule configuration in SD-WAN deployments.
Example configuration (Central SNAT Using SD-WAN Zone).
config firewall central-snat-map
edit 1
set src-addr "internal_subnet"
set dst-addr "all"
set protocol 6
set srcintf "LAN"
set dstintf "SDWAN_ZONE"
set orig-ports 0-65535
set mappedip "203.0.113.100"
set mapped-ports 0-65535
next
end
In this example:
SDWAN_ZONE refers to the SD-WAN zone name defined under config system sdwan.
The mapped IP is applied when egress traffic exits via any interface in that zone.
Feature Availability.
Available in FortiOS v7.6.1 and later via both GUI and CLI.
Additional Policy Types Supporting SD-WAN Zones.
Local-In policies.
DoS policies.
Multicast policies.
TTL policies.
Operational Considerations.
Ensure that the SD-WAN zone used in Central SNAT matches the zone configured in config system sdwan.
Using zones instead of specific interfaces allows broader and more resilient rule application across all member interfaces.
This capability enhances maintainability in dynamic WAN environments.
