Technical Tip: Monitoring performance SLA reduced in the GUI from 10 minutes to 1 minute

[a677579]

Description	This article describes a change on the GUI related to Performance SLAs on SDWAN.
Scope	FortiOS v7.4.8 and above.
Solution	A change has been made to the default behavior of the Performance SLA history. Before FortiOS v7.4.8, a 10 minute historical graph was shown under Network -> SD-WAN -> Performance SLAs. On FortiOS v7.4.8 and higher, this 10 minute history can be seen only through the CLI. The GUI will show only a 1 minute history graph. This is the new default behavior and cannot be changed. The 10 minute history can be viewed in the CLI. First, check the name of the health-check and the sequence. diagnose sys sdwan health-check Health Check(Default_DNS:( Seq(2 port1): state(alive), packet-loss(0.000%) latency(7.820), jitter(0.364), mos(4.400), bandwidth-up(9999998), bandwidth-dw(9999941), bandwidth-bi(19999939) sla_map=0x1 Seq(3 port2): state(alive), packet-loss(0.000%) latency(13.273), jitter(0.589), mos(4.397), bandwidth-up(9999998), bandwidth-dw(9999994), bandwidth-bi(19999992) sla_map=0x1 diagnose sys sdwan sla-log Default_DNS 2 Timestamp: Thu Dec 11 08:22:26 2025, vdom root, health-check Default_DNS, interface: port1, status: up, latency: 7.833, jitter: 0.517, packet loss: 0.000%, mos: 4.400. <10 minute records> Timestamp: Thu Dec 11 08:32:26 2025, vdom root, health-check Default_DNS, interface: port1, status: up, latency: 7.975, jitter: 0.837, packet loss: 0.000%, mos: 4.400. See Monitoring system event logs under Monitoring performance SLA v7.4.8.