Description
This article describes the steps to create a VLAN interface (802.1q tag) on a FortiGate.
Scope
Any FortiGate.
Solution
Note about traffic tagging:
A VLAN interface is attached to a physical interface.
A VLAN interface is attached to a physical interface.
When the FortiGate sends out traffic to the physical interface level, the egress packets are untagged, whereas the packets sent on a VLAN level are tagged.
If on a particular VLAN there are destination devices in the network that do not accept tagged packets, it will be required to connect the FortiGate to an intermediate L2 unit (a switch for example) configured with the same VLAN(s).
Below is an example structure with a FortiGate with VLAN id 1 attached to port1:
Below is an example structure with a FortiGate with VLAN id 1 attached to port1:
[ FortiGate ] ---- port1 -----> untagged packets
----VLAN1 (on port1) -----> tagged packets
Configuration steps to add the VLAN 100 to the physical interface port1 through both the CLI and GUI are provided in this article. The VLAN will be named My_VLAN_100.
Notes:
- Once created, this interface is subject to the same rules as physical interfaces. Firewall Policies must be defined to allow/deny traffic to/from this interface, and other common objects like Firewall Address can be assigned to it.
- The physical interface on which a VLAN is attached does not require any IP address settings.
-
The physical interface on which the VLAN is attached will share the bandwidth with all the VLANs attached in the physical interface.
-
The VLAN ID range is from 1 to 4094. VLAN ID of 0 is reserved for high-priority frames, and 4095 is reserved.
Configuration steps from the GUI:
- Go to System -> Network and select 'Create New' -> 'Interface'.
- Give a Name to the VLAN interface.
- Choose the physical interface on which to attach the VLAN.
- Give the desired VLAN ID. All other fields depend on individual requirements, such as IP address and ping server.
- After completing the above steps, select 'Ok' to save the new VLAN interface.
To verify, check the interface in System -> Network -> Interfaces, by expanding the physical port. There, the new VLAN should be displayed:
Configuration steps in the CLI for the above VLAN:
config system interface
edit "My_VLAN_100"
set vdom root
set ip 192.168.100.1/24
set interface internal1
set vlanid 100
next
end
Related articles:
