Technical Tip: How to clear utilization of the disk partition from the WAD process on FortiGate

[mayurhadpe]

Description	The article describes how to clear disk utilization from the WAD process.
Scope	FortiGate.
Solution	To check utilization of the partition, see step 4 in Technical Tip: FortiGate hard drive and SMART status. If the WAD process is consuming too much memory ('diagnose system top-mem'), use the following debug commands to clear the partition. diagnose debug enable diagnose test app wad 21200 diagnose test app wad 98 Wait for a while, and then disable the debug commands. diagnose debug disable Note: Clearing the partition with the command above will impact traffic. Check the partition utilization with 'fnsysctl df -k' and confirm the partition has been reset.