Description
This article shows how to change the speed and duplex for individual interfaces under switch mode.
Scope
FortiGate.
Solution
config system virtual-switch
(virtual-switch) # edit internal
(internal) # config port
(port) # edit internal1
(internal1) # show full-configuration
config port
edit "internal1"
set speed auto
set status up
set alias ''
next
end
(internal1) # set speed
auto Automatically adjust speed.
10full 10M full-duplex.
10half 10M half-duplex.
100full 100M full-duplex.
100half 100M half-duplex.
1000full 1000M full-duplex.
(internal1) # set speed 100full
(internal1) # end
(internal) # end
#
After changing the speed and duplex, the status of the interface can be checked by using the command 'diagnose hardware deviceinfo nic [interface]' as shown below:
diagnose hardware deviceinfo nic internal1
Driver Name :Fortinet NP4Lite Driver
Version :1.0.1
Admin :up
Current_HWaddr 08:5b:0e:da:4b:26
Permanent_HWaddr 08:5b:0e:da:4b:26
Status :up
Speed :100
Duplex :Full
Host Rx Pkts :0
Host Rx Bytes :0
Host Tx Pkts :0
Host Tx Bytes :0
Rx Pkts :12
Rx Bytes :1050
Tx Pkts :7
Tx Bytes :630
rx_buffer_len :2048
Hidden :No
cmd_in_list : 0
promiscuous : 0
enabled 802.1x : 0
authorized : 0
mac bypass : 0
#
Note:
This command is only supported for v6.2 or below.
