interface down!

[Reynolds]

Good night! Is there a way I can activate my physical interfaces without having to go to the site?

[esalija]

Hi @Reynolds ,

From the CLI, to enable the interface that you want:

config system interface

edit port<port_number>

set status up

end

Best regards,

Erlin

[Hemin88]

Hi Reynolds,
You should have reachability to the Firewall, if you already have: 

config system interface

FW-01 (interface) # edit lan1   \\replace lan1 with your intended interface 

FW-01 (lan1) # set status up

FW-01 (lan1) # end

if you don't have access and you don't want to visit the site, just let someone connect his PC to the firewall and get an IP from the management subnet of your firewall, you can remotely get access from his PC and repeat the same steps above.