Hi Folks!
Looking to see if anyone knows anything about this, but basically I've got a Fortigate 500D setup with SSL VPN Portal with Split Tunnelling setup, and running into an issue where when users connect via Tunnel Mode into the SSL VPN Portal the routes showing up in their Windows Clients under route print are not similar to the Static Routes shown in the Fortigate, because of this they cannot access certain Routes but can access the same routes when they are in the office on a network that has policies allowing them to.
Software Version: Fortigate 500D 5.2.3
Troubleshooting Performed:
1. Clean FortiClient Installation.
2. Multiple Browsers tested.
3. Different ISPs
4. Re-Verified Remote SSL/VPN Portal Policies.
