Reg Gui Access

[Ashu27]

Hi,

I have create three vlan in firewall on port 5.
and i am using Cisco Access point Mobilty express. and i create three SSID and attach it with 3 different Vlan.
Now my problem is when i connect to this Access Point to firewall than i am unable to take GUI of Access Point,
And when i connect to ethernet cable direct to my laptop then i got GUI of this.
Anybody tell me what part is missing in firewall.

[DeepKuma2]

Hi, 
Let's start from WIFI tshoot:
Connect laptop wifi and login in Mobility controller:

1. Are you able to ping Firewall IP?
2. Is there any Access List configured on the Mobility controller?

Check a few points on the firewall:
A: Did you assigned any another Role to the VLAN ID?
B. Any Management ACL configuration?
c. If there is any Zone then did you assigned GUI, Telnet access?



------------------------------
Deepak Kumar
First Option General Trading LLC
Dubai
------------------------------

[Ashu27]

Yes i am ableto ping Gateway of that vlan
and i did not create any ACL rule on AP.

[DeepKuma2]

Hi,
Can you check the "Access" TAB on the "Interface" menu under the "Network" menu, Do you have HTTPS, HTTP access rights?

------------------------------
Deepak Kumar
First Option General Trading LLC
Dubai
------------------------------

[Ashu27]

ya already enable it.
one more thing i am also unable to ping the management IP of AP, when connect to SSID of that Particular VLAN.
when connect to the firewall.

[DeepKuma2]

Hi,
I got your point. Configure LAN to LAN Firewall rule. It will resolve the issue.

------------------------------
Deepak Kumar
First Option General Trading LLC
Dubai
------------------------------

[AnonMemb]

This post was removed