Cybersecurity Forum

This forum is for all security enthusiasts to discuss Fortinet's latest & evolving technologies and to connect & network with peers in the cybersecurity hemisphere. Share and learn on a broad range of topics like best practices, use cases, integrations and more. For support specific questions/resources, please visit the Support Forum or the Knowledge Base.

JohnKall
New Contributor

Powering Down Fortinet Appliances

Hi,

I was assigned to make a power down plan for the Fortinet Appliances that we use in the data center.

We have FortiManager, FortiGate, FortiAnalyzer and LoadBalancer for equipment.

How do I power them down?

Is there a specific order that I should follow?

How do I take the configuration backup?

 

Thanks 

John

5 REPLIES 5
AndrKuhn
New Contributor

Hi John,

Create Backup (OS 5.2):

For FortiManager + FortiAnalyzer go to tab System Settings > Dashboard > Widget System Information > System Configuration > klick Backup

For FortiGate go to Dashboard > Status > System Information > System Configuration > klick Backup


For Power-Down: just unplug or push the button (if existing)


Kind regards,
Andreas

DrWolfgangBeneicke1

Uh-oh.

I strongly recommend against "just pull the plug". Depending on the FGT model used they may be equipped with an internal disk (SSD) which will take offense in being switched off without proper shutdown.

Next time the FGT is booted a warning will be displayed that a file system check is due - with reboot. And you are well advised to permit it asap.

Same for FAZ or FMG with internal disk(s).

So, before switching off the power you shut the appliances down. In the GUI, on Dashboard/Resources widget, hit 'Shutdown'. You may enter a reason for it, later to be seen in the logs. It only takes a couple of seconds to stop all services and 'halt' the OS. Unfortunately, you cannot notice...except for on the console (serial) port.

In the CLI, just 'exec shutdown' and confirm with 'y'.

Per se, shutdown does not need to be preceeded by a backup operation. It surely never hurts but is not mandatory. Changes to the configuration always are written to flash. With the 'auto-config-save' option set, point-in-time backups are saved to flash every time you change the config.

Ede

JohnKall

Thanks Ede,

I will follow your advice.

By the way, do you have in mind any video training tutorials for fortinet products? Especially FortiManager, FortiADC and FortiGate, not just only Fortinet provides?

 

John

DrWolfgangBeneicke1

Check out the Fortinet Video Library - http://video.fortinet.com . They feature a lot of products there, and even Cookbook recipes on video.

AndrKuhn

Uh - didn´t have this disk thing in my mind, you´re of course correct, and proper shutdown doesn´t cost that much amount of time...   thanks for notice!

Announcements

Select Forum Responses to become Knowledge Articles!

Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.