Skip to main content
prot
prot
New Member
October 11, 2021
Question

VPN Site-to-Site access

  • October 11, 2021
  • 2 replies
  • 4444 views

Hi,

 

We have site-to-site IPsec VPN that works fine.

Our HQ network is 192.168.123.0 and branch is 192.168.10.0

 

Then we have another IPsec VPN that connect to our HQ, the problem is now that when we are connected to HQ VPN we can not acces branch network, already did Firewall policy so its not blocking it but it is still unreachable - Accept: session timeout

 

What else do we need to configure ?

 

Thank you for your help!

    2 replies

    mhe
    mhe
    Explorer II
    October 11, 2021

    Do you have setup the routing in your branch office to include the VPN Range via HQ?

    prot
    protAuthor
    New Member
    October 11, 2021

    Well i believe IPsec Point-to-Point wizard already did it ?

    As localy in HQ i can access branch network, only when im connected to HQ IPsec i cant.

    mhe
    mhe
    Explorer II
    October 11, 2021

    besides believe you can also verify it in the routing monitor

    spanz
    spanz
    Visitor III
    October 13, 2021

    if the IPSEC tunnels configured to use "no NAT between sites",

    On the branch - did you verify that you have a static route points to the protected subnets of the site which is tunneled to the HQ appliance from the other side ?

     

     

     

    Terms & ConditionsAccessibility statement