Skip to main content
malakibrahim
malakibrahim
New Member
February 18, 2021
Question

VPN Manager - hub behind NAT device

  • February 18, 2021
  • 1 reply
  • 2807 views

Hello 

I have a hub and spoke topology created via VPN manager on FMG, the Hub is behind a NAT device (hub is configured with a private IP address), where can I configure the public IP address of the hub? if the ISP is connected via two ISP can I configure two public IP addresses instead of only one? 

 

1 reply

sw2090
SuperUser
sw2090
SuperUser
February 23, 2021

a vpn tunnel (hub aswell as spoke) is always tied to an interface.

So tie it to the WAN interface you want to use.

The interface ip wil be the ip the tunnel uses as source ip.

 

There is also some way to use sd-wan but I never tried to.

Terms & ConditionsAccessibility statement