Skip to main content
lnhquang1993
lnhquang1993
New Member
December 24, 2017
Question

VPN between Fortigate and Cisco RV130 VPN Firewall

  • December 24, 2017
  • 1 reply
  • 6396 views

Hi everyone,

I have problem with my VPN config. I try to establish a site to site VPN but it not working.

My Fortigate stand behind Peplink but I was configure NAT mapping for it. The Phase 1 neotigate success but it still not working.

Here is my config and some log : [image]https://ibb.co/mvUpzm [link]https://ibb.co/dhQUzm[/link] [link]https://ibb.co/fneBC6[/link] [link]https://ibb.co/chENKm[/link][/image]

 

    1 reply

    Sidewaysguy
    Sidewaysguy
    New Member
    December 24, 2017

    Hi there,

     

    I'm not familiar with Peplink.  In your config are you NAT'd or do you have a public IP?  How about the other side?

     

    Cheers,

     

    Sidewaysguy

    lnhquang1993
    lnhquang1993Author
    New Member
    December 26, 2017

    Hi,

    Don't mind abount Peplink cause i was config NAT mapping on it. So, all the traffic will be forward to Fortigate. 2 IP public is on Peplink. WAN interface of Fortigate using IP Private. The Orther site using Cisco RV130 VPN Firewall. As i said before, Phase 1 is success and i see it in Log and Report > VPN Event on Fortigate. But Phase 1 í being deleted right after it. I don't know why 

    Terms & ConditionsAccessibility statement