Skip to main content
piacas
piacas
New Member
September 21, 2017
Question

Virtual IP doesn't show up in list

  • September 21, 2017
  • 1 reply
  • 27370 views

Running v5.6.2, created a VIP under DNAT & Virtual IP's with a port forward.

Create a new policy and when select destination, the VIP isn't listed, only addresses. I made for interface setting in VIP and poicy are the same for incoming. Anyone seen this? I've made VIP's in 5.4/5.2 the same way and worked fine....

 

 

 

Thx

Dave

1 reply

Toshi_Esumi
SuperUser
Toshi_Esumi
SuperUser
September 21, 2017

I quickly tested 5.6.2 w/ FWF60D but as long as the interface is matching (I used wan2), the port-mapping I configured shows up in the "Select Entries" on the right side of the GUI screen.

piacas
piacasAuthor
New Member
September 21, 2017

And thats what I've seen before on other units. this is a demo 100D and it doesn't show up. I tries with matching interfaces, using 'any', just doesn't show up....

Toshi_Esumi
SuperUser
Toshi_Esumi
SuperUser
September 21, 2017

I'm almost sure it would still work if you configure it via CLI.

Terms & ConditionsAccessibility statement