Virtual IP allow multiple service ports?

2 ways at least: I don' t know which one would be more efficient at this moment Former seems to permit more granular control and latter seems to be easier to maintain. 1) define one VIP for each service with " port-forwarding" and create policies respectively 2) you could set a service-group (ex: myservices) including these protocols config firewall service group edit " myservices" set member " HTTPS" " HTTP" " SMTP" next end After that you only need create your VIP allowing these service-group config firewall vip edit " MyservicesVIP" set extip <THE SECONDARY IP> set mappedip <EXCHANGE SERVER' s LAN IP> set extintf " wan1" next end And apply your appropiate policy, i.e.: config firewall policy edit " <new_id_policy>" set srcintf " wan1" set dstintf " internal or dmz_i don' t know" set srcaddr " all" set dstaddr " MyservicesVIP" set action accept set schedule " <as_required>" set service " myservices" set profile_status enable set logtraffic enable set profile " strict" next end regards

Just remember, if you use port-forwarding, rather than static NAT, then the outbound connections from the VIP ip addresses will be natted using the firewalls external ip address, rather than the VIP' s external address. In other words, as an example, if you mapped smtp (25) to the mailservers internal ip address, when the server sends emails, it will originate from the firewalls IP address, rather than the VIP' s external IP. A static nat does the reverse, it will use the VIPS address for outbound. So, if you need it to send out on the VIP address, you will need to add poilsy rules for these internal devices, to specifically use a pool (containing the one vip IP) for it. Hope that makes sense, its a confusing subject for some.