Skip to main content
grantjonas22
grantjonas22
New Member
November 13, 2016
Question

Using LAGs on FG600D HA Cluster

  • November 13, 2016
  • 1 reply
  • 2482 views

Hey all, 

 

In short, I have 3 switch stacks that each connect to a FG600D HA Cluster, via 1G SFP ports. My problem is that I would like to configure 802.3ad LAGs from the switch stacks to the 600D's, 3 stacks so that would use 6 ports total. 

 

I have created a software switch on the Master 600D so that it could trunk each respective link to switch's and route between the switches VLAN's. However, there does not seem to be a way to add the LAGs running from the switches to the 600D's software switch. 

 

Is there a way to have LAG's on a 600D's software switch? Or is there maybe another switch mode that I could use on the 600D's to accomplish this goal? 

 

Appreciate any help, or advice!

 

Thanks!

    1 reply

    Kenundrum
    Kenundrum
    New Member
    November 16, 2016

    On my 500D cluster, I simply created an 802.3ad aggregate interface on the cluster, assigned the physical ports to it. This creates the interface on all cluster units. I created matching 802.3ad interfaces on the switches and plugged the cables from the switch interfaces to the FW interfaces. On the firewall, you then need to add VLAN interfaces on the aggregate interface to do VLAN traffic.

    Terms & ConditionsAccessibility statement
    Thought Leadership. Security Summit. Thursday, November 12th, PGA National Resort, Palm Beach Gardens, FL.
    Thought Leadership. Security Summit. Thursday, October 8th. Disney's Grand Californian Hotel & SPA, Anaheim, CA.