New Member

Solved

Upgrade fortimail in HA active-passive

Forum|Forum|1 year ago
September 25, 2024
2 replies
2149 views

Hi,

We need to update Fortimail which is in an Active-Passive HA architecture, but we don't know if we should upload the firmware image to the Primary Device and this Primary Device is automatically updated itself and the Secondary unit likewise similar to FortiGate with this architecture. Or on the contrary, we must update the Secondary Unit manually, set this unit as Primary and update the unit that was previously primary.

Could you please resolve this doubt?

Thank you all.

Best regards.

FortiMail

Best answer by andresruiz

Hi,

Ok AEK, thanks for all and best regards.

AEK

SuperUser

Hi Andres

Start by the secondary.

Check this guide (this is for 7.6.x).

https://docs.fortinet.com/document/fortimail/7.6.1/administration-guide/725928/upgrading-firmware-on-ha-units

AEK

andresruizAuthor

New Member

Hi,

Do I upgrade the secondary unit first and then force manually failover the primary to become secondary? Or do I upgrade the secondary unit and then the primary directly without performing manual failover?

Another question, is the manual failover forced using the execute ha commands failover-start command on the primary unit?

Thanks for all.

Best Regards.

AEK

SuperUser

Hi Andres

I did a firmware update 2 years before and followed the exact procedure shared above.

In my case I didn't need to perform a manual fail-over but I the operation was scheduled in low traffic hours since there is about 2 or 3 minutes downtime.

But don't worry, no mail will be lost since the SMTP servers and other MTAs keep trying after a failed attempt.

AEK

andresruizAuthor

New Member

Can anyone who has recently upgraded fortimail in HA Active Passive architecture give me feedback to consider as well, please?

Thanks.

Sign up

Login with SSO

Login to the community

Login with SSO

Scanning file for viruses.

This file cannot be downloaded