Skip to main content
kevin_bieliauskas
kevin_bieliauskas
New Member
October 5, 2021
Question

Unable to reach our destination network, from an upgrade windows 7 to Windows 10

  • October 5, 2021
  • 1 reply
  • 1931 views

Hello,

 

I did not find any answer to my issue on this forum,

I have an issue very strange with Forticlient VPN

 

I connected to a VPN without any problem, i get an IP from VPN range

 

When i try with Windows 7 (VM)  on VMWARE it works fine to connect, i can ping an IP (192.168......)

when i try with Windows 10 (VM) on VMWARE it works fine to connect, but when i try to ping the same IP, it does not work.

When i try with windows 10, on my laptop it works fine to connect, i can ping this iP (192.168...)

 

We try with differents version 6.0 & 7.0

we compare all our configurations.

We try to add a static route.

We remove IPV6 from our network card and adapter.

 

Please could you help me :)

 

Best regards

 

 

    1 reply

    A
    Anonymous_User
    Contributor
    November 23, 2021

    Hello @kevin_bieliauskas ,

     

                             Could you please confirm following information

     

    - Are you using split tunnel in the VPN config, if yes can you verify the routes on the host after making the VPN connection using the following command

     

    route print

     

    - Please make sure you see the route for the respective IP or subnet via the tunnel, if that is verified we will need to run a sniffer on the firewall to see where the packet is being dropped.

     

    Regards

     

    Terms & ConditionsAccessibility statement