Skip to main content
Yogesh4chat
Yogesh4chat
New Member
October 13, 2016
Question

Trying re-configuring FG100A on Console but not booting

  • October 13, 2016
  • 1 reply
  • 3268 views

Dear Forum,

 

I am trying to re-configure FG100A through console cable as Admin pwd and IPs are not known. at consle (Putty)  it is displaying only two lines :

 

FG100A (19:06-02.28.2006) Ver:04000003

 

then it halts.

 

Please suggest how can I move further

    1 reply

    MikePruett
    MikePruett
    New Member
    October 13, 2016

    That is a really old device. I would probably suggest buying new. If that isn't possible, considering the age it may be a hardware fault.

     

    Were changes made that caused it to go from working to not working?

    ede_pfau
    SuperUser
    ede_pfau
    SuperUser
    October 13, 2016

    It looks like it's not booting the firmware - flash crashed or fw damaged somehow. You can try to reload the firmware from the boot monitor; on the console, hit any key when booting to get into the menu. You will need a matching firmware image file (*.out) and a TFTP server, the serial connection to watch and a TP cable for the data. Older FGTs required a LAN connection on port1 only - YMMV.

     

    (strange, I thought I'd already posted this a couple of hours ago. Getting old.)

    Terms & ConditionsAccessibility statement