Transparent Mode: cant access management

A couple of possible things could be stopping this; 1. you have a clash on that IP address on the network (see tip below) 2. You dont have the https access ticked on the interface that you trying to access it (internal usually) 3. You have restricted the admin users to only come from certain ip addresses. have you tried telneting, or ssh' ing to the unit ? in case https is just off. If you use a proxy, have you tried disabling the proxy in the web browser? from a windows machine, try the following cmd line; nbtstat -A 10.0.0.10 if it comes back with a workgroup/pc name. then its clashing with a windows machine on the network.

The odd thing is I was able to connect to it from home by going thru the cisco vpn... 1. no clash on ip. nbtstat -A 10.0.0.10 = host not found. 2. https was/is active 3. woops, while connected from home I did set it for admin access from my office workstation ip (10.0.0.29 in the first of the three fields), then I lost the connection. now I can' t log in from anywhere. I' ll try playing with it on an isolated network to see if I can access it. will try telneting...

Thats the problem, the external port of the firewall only has access, hence why you could get in initially from home. Then when you set the workstation restriction you limited it to this IP only. If it doesnt work from that workstation IP, then plug that workstation into the outside port/switch, then you will be able to access it to turn the internal one on. (or briefly swop the two cables over in the two ports, making the external port on the inside.) Otherwise see if you can logon via the console, as you can change the access via the command line.

woohoo! I' m in. switching int<->ext cables worked. Do you mean I have no access from the inside?

Logon to the gui, goto the internal port properties and enable the https/ssh access. Once you have done that, you can swop the cables back over and voila...

solved! Thanks Uk!

You' re welcome.