SW-WAN Rules failed to save changes

Forum|Forum|3 years ago
October 16, 2022
6 replies
6162 views

Hi everyone,

I've a strange issue with my Fortigate 60F and SD-Wan Rules.

When I go to the SD-WAN Rules, i've constanelly the loading spinning without results :

If I retry after a couple of refresh or after go to another menu the page is finally displaying the rules.

But i cannot change the order and receive an error :

I was previously with the 7.2.1 and change to 7.2.2 after the announce of fortinet to upgrade immediatly due a leak on the previous firmware but i don't think this is the cause.

At this time i can only create or delete rules and i've only tree rules : default, rule for a computer and default implicit with "source-destination IP"

Can you help me please.

FortiGate

dgitsAuthor

Visitor III

nobody ?

esec

Visitor III

Haven´t experienced the same issue, but when I have issues in the GUI I normally do the same thing in the CLI and hopefully get a error describing why you can´t do the change in the GUI.

You can also start a SSH session to the Fortigate and run CLI debug to see what commands that are being done in the GUI -> Technical Tip: Verify configuration in CLI - Fortinet Community

If the above doesn´t solve it I would remove all SD-WAN rules and re-create them and hope that solves it.

dgitsAuthor

Visitor III

Thanks esec

I've already try with new rules (with a factoryreset).

I've also try to move the SD-WAN rules (to change order) but i've still the problem (Failed to save changes). When I move a rule, nothing happens from SSH diagnose side.

When I update a rule, i've been the command with this result :

write config file success, prepare to save in flash

[__create_file_new_version:274] the new version config file '/data/./config/sys_vd_root+root.conf.gz.v000000016' is created
[symlink_config_file:341] a new version of '/data/./config/sys_vd_root+root.conf.gz' is created: /data/./config/sys_vd_root+root.conf.gz.v000000016
[symlink_config_file:385] the old version '/data/./config/sys_vd_root+root.conf.gz.v000000015' is deleted
[symlink_config_file:387] '/data/./config/sys_vd_root+root.conf.gz' has been symlink'ed to the new version '/data/./config/sys_vd_root+root.conf.gz.v000000016'. The old version '/data/./config/sys_vd_root+root.conf.gz.v000000015' has been deleted
zip config file /data/./config/sys_vd_root+root.conf.gz success!

I've also try with downgraded to the firmware 7.2.0 and that's works with this version !

So what's happening from 7.2.0 to 7.2.1 and 7.2.2 with sd-wan ??!!

The only changes I see is the ipv6 all on the implicit default rule :