Static Routes issue using 6.0.3 Firmware

Forum|Forum|7 years ago
October 18, 2018
2 replies
36481 views

Hi guys,

I am using the new firmware version (6.0.3) and I got one issue using static route. If you already have any route to a specific GW and you try to add a new one to the same specific GW, the Fortigate shows the follow message.

"Gateway IP and interface conflict with Static Route #"

How to fix it?

Save your route using another GW IP. After that, right-click on the Route you want to change and click ">_Edit in CLI".

Run the command "set gateway 10.1.3.5", then type "end" and close the CLI Console.

Refresh your browser and you will see the result.

@Fortigate team, please provide an update to fix it up.

tanr

New Member

Were you adding the new route with identical distance and priority? If so the error would make sense, since you don't want to do that unless it's part of a specific load balancing setup.

Edit: Ignore this - I thought you said it was the same destination, not gateway. Ede has it right.

ede_pfau

SuperUser

No no, you can usually use the same gw and interface for a couple of routes. Imagine a dozen remote subnets behind the next router...so definitively a glitch in the GUI check.