splitting traffic on 2 links

Forum|Forum|8 years ago
September 25, 2017
4 replies
6280 views

Good day dears

i have internal network with 1 and with 3 wan connections

i want to make some ip's go through wan1 and some through wan2 and the rest through wan3

how can i do that without load balance

my device is 300D and firmware is 5.4

Sunil_Panchal_NSE7

New Member

Dear friend ,

this can be done through simple policy with taking care of internal interface and wan interface .

just do not create any load balancing interface just with proper and normal policy

eslam_hassaneinAuthor

New Member

superindian wrote:
Dear friend ,
this can be done through simple policy with taking care of internal interface and wan interface .
just do not create any load balancing interface just with proper and normal policy

dear i have tried this but the traffic is going by one link only.

Sunil_Panchal_NSE7

New Member

dear friend ,

when you are creating the policy

like outgoing interface ,incoming interface , source.......that time you have to see the flow

source should be ip range or host ip you want to route with specific wan.

example you have 3 internet means 3 wan interface and internal network may be host 192.168.1.10,192.168.1.20 and reset

so you have to create policy like policy-1wan1 outgoing interface -incoming interface lan1 source 192.168.1.10

policy-2 wan2 outgoing interface -incoming interface lan1 source 192.168.1.20

policy-3 wan3 outgoing interface -incoming interface lan1 source other network

you will get result what you want

BUT BE CAUTION FIREWALL POLICY WORK TOP TO BOTTOM

IF YOU PUT ALL NETWORK POLICY AT TOP ,ALL USER WILL GO THROUGH ONLY ONE WAN .

Sign up

Login with SSO

Login to the community

Login with SSO