Skip to main content
newNetwork
newNetwork
New Member
October 14, 2015
Question

SOLVED:add default route when Wan link load balance is in place

  • October 14, 2015
  • 1 reply
  • 8598 views

I have wan link load balance configured on this FW, when i try to enter default route with higher distance for the third wan link on port3 , i get an error . config router static edit 6 set gateway 202.1.1.1 set distance 50 set device "port3" next end -----------i get this error

duplicate entry object set operator error, -15 discard the setting

 

    1 reply

    newNetwork
    newNetworkAuthor
    New Member
    October 19, 2015

    This is a known and open bug#258977.

    Default route when Virtual WAN Link/WAN Link Load Balance is enabled When Virtual WAN link is enabled and a default route exists for the VWL, you cannot add another static default route entry for another interface whose IP address is manually configured and that is not part of the VWL. You receive the error "Duplicate entry found".

     

    newNetwork
    newNetworkAuthor
    New Member
    October 19, 2015

    Workaround is to remove virtual-wan-loadbalance route and use two default routes with equal cost each on wan1 and wan2 and then add any other default routes required.

    I still needs to test it though.

     

    dphills
    dphills
    New Member
    December 19, 2016

    This bug needs to be fixed.  This will break my spillover functionality.  

    Terms & ConditionsAccessibility statement