should fortilink interfaces be monitored?

Greetings!

In a High Availability (HA) setup, monitoring FortiLink interfaces can be crucial, especially if they are handling critical traffic. However, there are some best practices to consider:

1 Monitor Critical Interfaces: Only monitor interfaces that are critical for your network operations. If FortiLink interfaces are critical, they should be monitored.

2. Avoid Monitoring All Interfaces: Monitoring too many interfaces can lead to unnecessary failovers. Focus on those that are essential for maintaining network connectivity and performance.

3. Exclude Heartbeat Interfaces: Ensure that the heartbeat (hbdev) interface is excluded from monitoring to prevent unnecessary failovers.

4. **Setup Considerations: Configure the monitor interfaces only after the HA cluster is fully set up, synchronized, and operational to avoid premature failovers.

5. Evaluate Downtime: If monitoring FortiLink interfaces leads to increased downtime during failover, consider whether the benefits of monitoring outweigh the potential downtime.

By following these best practices, you can optimize your HA setup and minimize downtime during failover scenarios.

Regards!

Hi Celik

I think in such scenario you don't need to monitor the FortiLink interface.

You have 2 FSW, so the FortiLink interface will fail if both FSW fail or both are disconnected from your primary FGT, and I think this is very unlikely to happen.

Now in case both FSW fail then there is really no need to automatic FGT failover, right?

And in case both FSW cables are disconnected from the primary FGT then this is most probably due to a voluntary manual intervention.