Session table and 2 ISP

Hi Jan,

This is normal behavior.  It would generally be undesirable to break a session just because another route became available.  If it's SIP like you mentioned, any phone calls in progress would be dropped when you clear the sessions.

However, I have run into this as well where I want our SIP connections to consistently go out one ISP unless that one is not available.  The problem is that ISP performs maintenance frequently and I would find that my connection had failed over to my other ISP the next day.  My solution was to pick a time after their maintenance but before business hours and run a scheduled script to clear any of my SIP connections on the wrong ISP interface.  This would run daily, and if no connections had failed over there would be nothing to clear, but if something had it would clear it and reconnect on the "right" ISP.

This won't do *exactly* what you want, because I don't think you can schedule the script based on an event like that, but you could run the script more frequently if you wanted it to catch the issue sooner.  I just wouldn't recommend it because of it breaking active calls.

config system auto-script     edit "clearSIPsessionsToISP1"        set interval 86400          <-- 24 hours in seconds        set repeat 0        set start auto        set script "diagnose sys session filter clear diagnose sys session filter src x.x.x.x    <-- IP redacted, but this is my voice gateway that initiates all SIP connections.  You might be able to use a filter based on destination port for SIP (5060) to catch all connections diagnose sys session filter dint wan1     <-- the interface where the "wrong" ISP is connected diagnose sys session clear"     next

end

- Daniel Hamilton