Second IPsec tunnel inactive with no activity
Hi All,
I have two custom IPSec tunnels setup on FortiGate from same local WAN interface connecting to remote site on different WAN interfaces. The first tunnel is up and running without issues, but the second tunnel shows inactive and show now activity under the events log. The tunnel interface behaves as if disabled but it's not. Any ideas where to start looking? Checked the setting again and again.
FortiGate firmware v7.0.15 build7480
Some details below:
get vpn ipsec tunnel summar
'HUB-V1' 197.245.xx.xx:0 selectors(total,up): 1/1 rx(pkt,err): 12247/0 tx(pkt,err): 16156/2
'HUB-V2' 169.255.xx.xx:0 selectors(total,up): 1/0 rx(pkt,err): 0/0 tx(pkt,err): 0/1
FW # get vpn ipsec tunnel details
gateway
name: 'HUB-V2'
local-gateway: 217.91.xx.xx:0 (static)
remote-gateway: 169.255.xx.xx:0 (static)
dpd-link: off
mode: ike-v1
interface: 'ppp2' (25) vrf:0
rx packets: 0 bytes: 0 errors: 0
tx packets: 0 bytes: 0 errors: 1
dpd: on-demand/unnegotiated
selectors
name: 'HUB-V2'
auto-negotiate: enable
mode: tunnel
src: 0:192.168.10.0/255.255.255.128:0
dst: 0:192.168.0.0/255.255.255.0:0
