Solved
sd wan redundancy question
Dear All,
i have a question on SD WAN redundancy , if i'm gong to use SD Wan rule & performance SLA for redundancy, below are the setting i did, just wonder base on which setting to determine the failover and priorities which circuit to use first ? for instance if wan1 down it will failover to wan2, and if wan1 resume, it will failover back to wan1, and how do i set if i want use load balancing and where to determine the % to use on which circuit ? any help would be appreicated
SD Wan rule
Interface selection strategy
Manual
Manually assign outgoing interfaces.
Best quality
The interface with the best measured performance is selected.
Lowest cost (SLA)
The interface that meets SLA targets is selected. When there is a tie, the interface with the lowest assigned cost is selected.
Interface preference
WAN1 (port1)
WAN2 (port2)
Zone preference
Measured SLA
Default_Google Search
Required SLA target
Quality criteria
Manual
Manually assign outgoing interfaces.
Best quality
The interface with the best measured performance is selected.
Lowest cost (SLA)
The interface that meets SLA targets is selected. When there is a tie, the interface with the lowest assigned cost is selected.
Interface preference
WAN1 (port1)
WAN2 (port2)
Zone preference
Measured SLA
Default_Google Search
Required SLA target
Quality criteria
below is the setting under performance SLA:
Link Status
Check interval 500 ms
Failures before inactive 5
Restore link after 5 check(s)
Check interval 500 ms
Failures before inactive 5
Restore link after 5 check(s)
Piaakit