Skip to main content
jase888
jase888
New Member
November 15, 2018
Question

SD-WAN not working

  • November 15, 2018
  • 1 reply
  • 11218 views

I have 2 broadband lines I wanted to load balance and follwed the Fortigate SD WAN setup guide then tested at SD-WAN Status and it can ping Google and says link up, so I then add this as the outgoing connection on my LAN policy and it cannot get the internet.

 

Where am I going wrong? I should add when I use just the WAN as the outgoing connection it works fine so there must be some Im missing but Ive run through the guide 3 times now 

 

Any ideas?

    1 reply

    Fullmoon
    Fullmoon
    New Member
    November 15, 2018

    please check the ff.

     

    SD WAN routes

    Static Routes

    Firewall Policy (NAT enabled)

     

    Does it display correct routes in your routing monitor?

     

    would you care to share what model and FortiOS are you using?

    siomyn
    siomyn
    New Member
    November 19, 2018

    If you configure sd-wan, make sure some configuration ;

    1. Enable SD-Wan, put interface member and dont forget to put the gateway of each ISP

    2. Create SLA to make sure link is up/down

    3. Create defaut route to SD-Wan

    4. Create policy from inside-to-sdwan with NAT enable

     

    it should be OK

    Terms & ConditionsAccessibility statement