Skip to main content
ms5080
ms5080
New Member
October 2, 2021
Question

SD-WAN interface select unable active pppoe wan1 and wan2 port

  • October 2, 2021
  • 1 reply
  • 3148 views
Hi I use the Fortigate 200e and firmware is ver.6.0.6. I wanna build SD-WAN with wan port1 and 2 which are pppoe ISP using. But open SD-WAN configration, cannot select of interface wan1 and 2.(don't display) Please kindly help above issue. Thank you.

    1 reply

    subramanis
    Staff
    subramanis
    Staff
    May 7, 2022

    Hello @ms5080,

    you can't add those interface if it's already referenced in any other configuration, and you have to remove the existing configurations associated  to those interfaces to add as a sdwan member.

     

    Please check the firewall policy, static routes etc..

     Refer to the following link to check the interface reference on the existing configuration

    https://community.fortinet.com/t5/FortiGate/Technical-Note-How-to-Check-Referenced-Objects/ta-p/194815

     

    Thanks

     

     

    Terms & ConditionsAccessibility statement