Skip to main content
wally_acdr
wally_acdr
New Member
September 14, 2016
Question

Restore of fortigate 40C in fortigate 60D

  • September 14, 2016
  • 1 reply
  • 4404 views
HI Gyus. Mi name is Walter. I want to do a restore a backup of a Fortigate 40C in a Fortigate 30C, because this Fortigate will replace to other. I did the restore but I have a error and can't doing.  Is this possible?   Thanks

    1 reply

    Toshi_Esumi
    SuperUser
    Toshi_Esumi
    SuperUser
    September 14, 2016

    I haven't tried it myself but this could possibly convert the config file between fortigate models. If this doesn't work, only way is manual conversion section by section. By the way, most likely you need to match FortiOS version between two units to use this tool. Good luck.

    https://www.fortinet.com/...ll/forticonverter.html

    ede_pfau
    SuperUser
    ede_pfau
    SuperUser
    September 15, 2016

    You cannot load a config file from one model into another model. The update procedure will check the header lines in the config file to prevent this - as it doesn't make sense. Most notably port names/numbering is different between models, and if an unknown port name (for example, "lan" instead of "internal") is referenced in a policy, the policy won't load and an error is created.

    If at all both units must run the same firmware version and patch level. Then, as @Toshi posted, you can cut&paste sections from the original config file via CLI to the new model. Note that a "new", factory-reset model already has a configuration which may contradict the config commands you enter.

     

    In short, especially on these small models, it would be easier and preferable to recreate the config in the GUI. Single data items, like IPsec VPN PSKs, can then be inserted manually if absolutely necessary.

    Terms & ConditionsAccessibility statement