Hi,
I recently restored a configure from my production 310B Firewall to my backup Firewall (Same model) after restoring the config I am getting very bad pings and spotty connectivity on all ports. I reset to default installed the same OS and then brought over the config. I would rather not build from scratch if I don't have to.
Thank You
Marc
Power cycle the equipment attached to the backup fgt; based on your description of the problem it's possible there is a duplex/mismatch. To be on the safe side, perform a "diagnose debug config-error-log read" from the CLI to see if there are any errors (doubtful if both devices are on the same firmware).
For duplex/speed mismatch, perform "diag hardware deviceinfo nic <interface> from the CLI and look for any errors. Alternately, run "fnsysctl cat /proc/net/dev" and check the 3rd/4th column values for errors.
Still having issues, run the HQIP test on the device in question.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
