Skip to main content
Jordan101
Jordan101
New Member
May 31, 2018
Question

Putty unresponsive when connecting to Console of Fortigate 110c

  • May 31, 2018
  • 2 replies
  • 9180 views

Hello, 

 

Networking newbie here. Im trying to recover the administrator password for a Fortigate 110C Router.

 

Im hard wired into the router itself, through the console port using RJ45 to serial, then serial to usb, which plugs into my laptop. I have the usb/serial adapter plugged into COM3 on my laptop.

 

I am using PuTTY as my emulator. Settings are COM3, Speed = 9600, Data bits = 8, Stop bits = 1, Parity = none, and Flow control = none.

 

When i try to open the console, putty just sits at a blank console. Pressing Enter key does nothing.

 

      2 replies

      Toshi_Esumi
      SuperUser
      Toshi_Esumi
      SuperUser
      May 31, 2018

      First you need to confirm if the problem is on your PC/laptop side or on FG110C console port side. Move your console cable to another device, like a cisco router or something you're sure the pinout of the console port is the same with FGT's. If you can get any echo back from that device when you type something like 'enter' your PC/laptop w/ the console cable is fine. Then 110C's console might have locked up, which regularly requires a power-cycle unless you can get in via SSH/telnet over an ethernet port.

      vinceneil666
      vinceneil666
      New Member
      June 1, 2018

      You could try for one of the other baud rates just to check.. someone might have changed it at some point.. you never know :)

       

      If someone has changed it, its probalby set to 115200 or19200 

      Terms & ConditionsAccessibility statement