Skip to main content
SubHero
SubHero
New Member
November 9, 2019
Question

PPPoE with static IP

  • November 9, 2019
  • 1 reply
  • 15969 views

Hi all,

 

I have an issue currently, my office is subscribing broadband with PPPoE connection with add on of 1 static IP. But when I want to configure on my interface wan,it seem firewall cant get the IP.

I already put the static IP in unnumbered IP but seem no avail. Link Status and administrative status is up but the status is failed.

Not sure how to do this. I try to do nat but seems not workin.

    1 reply

    sw2090
    SuperUser
    sw2090
    SuperUser
    November 11, 2019

    hm we do that here by doing pppoe just as usuall without any special settings. Once the connection is set to static ip it gets static ip from our ISP.

    The only other static lines we have do not do pppoe at all.

    emnoc
    emnoc
    New Member
    November 11, 2019

    You can't set a static ip on a PPPoE interface. That's a dynamic ip same as in DHCP. Your ISP does the framed-address via the PPPoE authentication in RADIUS and attribute 8. You need to ensure the  PPPoE dialup NAS is set correctly to assign you your static ip address.

     

     

     

    Terms & ConditionsAccessibility statement