Skip to main content
mehmetsaityilmaz
mehmetsaityilmaz
New Member
October 24, 2015
Question

Policy route and wan 1

  • October 24, 2015
  • 1 reply
  • 2814 views
Hello we have two wan line and when i create a policy route for wan 1 , my clients use wan 1 , no problem but then we have a web site in my local , for example wwww.blabla.com , when try to see wan 1 users , they can not , how can i fix it

    1 reply

    Somashekara_Hanumant
    Staff & Editor
    Somashekara_Hanumant
    Staff & Editor
    October 25, 2015

    Hi,

     

    Is the internal website www.blabla.com is published on WAN2 interface, if yes kindly create a policy route from Internal Interface source address with internal subnet and set the outgoing interface as internal and set the destination address as internal IP address of www.blabla.com IP address.

     

    Still if it is not working, kindly provide the below command output.

     

    get router info routing-table all

     

    Regards,

    Somu

     

    mehmetsaityilmaz
    mehmetsaityilmazAuthor
    New Member
    October 26, 2015

    Thank you so much , it is work , Regards

    Terms & ConditionsAccessibility statement