Notitication email

Hello @Agus,

How is the notification email configured on Fortigate? Automation stitch or something else? Kindly share the notification email config.

Best Regards,

Mohammed Ahmed

Probably because you didn't configure "set reply-to" under "config system email-server" in CLI.
https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-configure-alert-email-settings/ta-p/194102

Toshi

Hi All,

Sorry for late reply and thank you for the contribution, here is configuration on our site

• On web panel menu:  log & report  -> Email Alert Settings

tick enabled 

From: myemail

To: recipient email

Alert parameter: event

•   From CLI

config system email-server
set reply-to "myemail@mydomain.com"
set server "notification.fortinet.net"
set port 465
set security smtps
end

Thank you

Maybe an issue with the old 6.0.2? The config looks fine.
My home 40F uses the same default "notification.fortinet.net" as SMTP server and no "reply-to" is configured. But it's 6.4.10 and the config has "set username" configured and the source email has this username in alert email. Does your 6.0.2 have "set username" command?

Toshi

Hi,

After i check detail on alert email for link-status monitor change

FG100E (automation-action) # edit "Link monitor change_email"

FG100E (Link monitor cha~ail) # show
config system automation-action
edit "Link monitor change_email"
set action-type email
set email-to "myemail@mydomain.com"
set email-subject "Link monitor change"
next
end

FG100E (Link monitor cha~ail) # set email-from myemail@mydomain.com

command parse error before 'email-from'
Command fail. Return code -61

FG100E (Link monitor cha~ail) #
set Modify value.
unset Set to default value.
select Select multi-option values.
unselect Unselect multi-option values.
append Append values to multi-option.
clear Clear multi-option values.
get Get dynamic and system information.
show Show configuration.
next Configure next table entry.
abort End and discard last config.
end End and save last config.

FG100E (Link monitor cha~ail) # set
action-type Action type.
email-to Email addresses.
email-subject Email subject.
minimum-interval Limit execution to no more than once in this interval (in seconds)

still confuse how to add mail from, so when receive alert have mail from address from myemail@mydomain.com not no sender receive that cause sent to junk folder.

Thank you