Skip to main content
sfareg
sfareg
New Member
March 20, 2017
Solved

not found wan1 to add at wan-load-balance

  • March 20, 2017
  • 3 replies
  • 12234 views

i want to configuration load-balance 

but found wan2 only

Best answer by ERNESTO_GARI

Greetings, you must deactivate routes, policies and objects that are associated with that interface, so that you can appear in the WLLB

3 replies

neonbit
neonbit
New Member
March 20, 2017

It's because WAN1 is already being referenced in policies, routes etc.

 

You need to remove all references to WAN1 before you can then add it to the wan LLB.

    ERNESTO_GARI
    ERNESTO_GARIAnswer
    New Member
    March 23, 2017

    Greetings, you must deactivate routes, policies and objects that are associated with that interface, so that you can appear in the WLLB

    sfareg
    sfaregAuthor
    New Member
    March 25, 2017

    thanks

    fred339
    fred339
    Explorer III
    October 11, 2022

    One way to preserve the policies, etc. instead of deleting them and starting over is to assign them to an unused interface.  So, if they are something like INSIDE > OUTSIDE and going to WAN1, change them to go from INSIDE > internal4 temporariliy.

    Then, when WAN1 is where you want it, you can change them back.  

    Easier to preserve things this way....

    Terms & ConditionsAccessibility statement