Skip to main content
Knox_122
Knox_122
New Member
May 16, 2018
Question

Not able to add devices to Fortimanager

  • May 16, 2018
  • 1 reply
  • 6643 views

A couple of issue have been popping up as of late. A few of our fortinets (ex:FortiWiFi 60D) Have not been able to register via the device GUI. I Put in all the info, but after I hit "OK", it spins and then nothing happens. I am also not able to add these devices to our Fortimanager.

The only way I am able to access these devices are through the Public IP. Though they are communicating across our network and working as they should, I am still not able to ping the management lan IP, add them to the Fortimanager or register them via the device GUI.

    1 reply

    flamer
    flamer
    New Member
    May 24, 2018

    Have you checked you have enabled "FMG" on the outside interface on the Foritgate?

    sw2090
    SuperUser
    sw2090
    SuperUser
    June 22, 2018

    If you want to access your Fortigate via Webinterface over an interface you have to have http and/or https enabled in this interfac's properties.

    For ping you have to have ping enabled there.

    If you want to be able to add a device to yoour Fortimanager then the interface the connection goes to has to have FMG ACCESS enabled.

     

    Plus of course you have to make sure (routing/policies etc) that the FortManager and you can reach the FOrtiGate ;)

    Terms & ConditionsAccessibility statement