No OSPF neighborship on VPN-Tunnel. What's wrong?
- September 18, 2018
- 1 reply
- 8158 views
Hello all,
I have trouble, getting an OSPF neighborship running through a VPN-Tunnel, and hope to get some ideas here. My test scenario is the following (s. picture appended): Two FWF60E connected via Point-to-Point Link on root VDOM, simulating the WAN-connection. A Test VDOM, that has access networks and a VPN tunnel to the opposite FN and OSPF routing enabled. The tunnel is routed via a VDOM Link to the root VDOM (as an virtual WAN Interface) and a static host route to the opposite Interface. There are not any other routes configured, because they should be learned via OSPF. The Test VDOM should not learn any routes from the root VDOM.
Both devices are configured symmetrically. Everything works fine. The tunnel is running an I can ping the opposite tunnel interface. The policy implicitly permits everything on all interfaces for test purposes. But no OSPF neighborship is established. The debug sniffer output shows that the local FN is sending OSPF Hellos to 255.0.0.5, source IP Tunnel Interface, as expected. But no hellos arrive at any side. Testequipment: FWF60E, v5.6.5
Any ideas whats wrong with the configuration? May the multicast address be an issue?
Many thanks in Advance! Hakan