Need enable Dynamic Threat Detection On FortiSASE managed Client

Hello UdaM,

Thank you for using the Community Forum. I will seek to get you an answer or help. We will reply to this thread with an update as soon as possible.

Thanks,

Hello,

We are still looking for an answer to your question.

We will come back to you ASAP.

Thanks,

Hello UdaM,

I found this solution. Can you tell us if it helps, please?

To enable Dynamic Threat Detection on a FortiSASE-managed FortiClient, you typically need to follow these general steps:

1. Log in to the FortiSASE Management Console: Use your credentials to access the management interface.
   
   

2. Navigate to the FortiClient Settings: Look for the section that manages FortiClient settings or endpoint security.
   
   

3. Locate Dynamic Threat Detection: Within the FortiClient settings, find the option for Dynamic Threat Detection or similar features. This may be under security settings or advanced settings.
   
   

4. Enable the Feature: Toggle the Dynamic Threat Detection feature to enable it. You may also need to configure additional settings related to threat detection.
   
   

5. Save Changes: Make sure to save any changes you’ve made.
   
   

6. Deploy the Configuration: If necessary, ensure that the updated configuration is pushed to the FortiClient endpoints.
   
   

For the most accurate and detailed instructions, it is always best to refer to the official Fortinet documentation or support resources. If you have specific configuration questions or run into issues, Fortinet's support team can provide assistance tailored to your setup.

Hi @Jean-Philippe_P 

Thank you for your replay. I guess these instructions relevant to FortiClient EMS. On the SASE i can only find below configuration related AV.

Appreciate your effort. I'll contact TAC team and update the result here.