Monitoring VPN Ipsec Phases 2 FortiOs 5.6

Buenas, estoy teniendo dificultados para ver el estado de las phases 2 de las VPN IPSec en la nueva version de Forti OS 5.6; ya que en Monitor>IPSec Monitor sólo muestra el estado de conexion de las phases 1; cuando en versiones anteriores se mostraba el estado de todas las phases (tanto 1 como 2), adjunto capturas. Como puedo hacer para el fortiOs 5.6 ver el estado de cada una de las phases 2?

Segun la doc, sacaron dicha funcionalidad:

IPsec monitoring pages now based on phase 1 proposals not phase 2 (304246) The IPsec monitor, found under Monitor > IPsec Monitor, was in some instances showing random uptimes even if the tunnel was in fact down. Tunnels are considered as "up" if at least one phase 2 selector is active. To avoid confusion, when a tunnel is down, IPsec Monitor will keep the Phase 2 Selectors column, but hide it by default and be replaced with Phase 1 status column.

Alguien sabe como verlo? 

Adjunto capturas de como se veía antes y como se ven ahora.

Comparativa FortiOs 5.6 vs 5.2.jpg                 

Loiacono Pablo ---------------------------------------------------------------------------- Good Morning, I'm having difficulty seeing the status of phases 2 of IPSec VPNs in the new version of Forti OS 5.6; Since in Monitor> IPSec Monitor only shows the connection state of phases 1. In previous fortiOs they showed the status of all phases (both 1 and 2), attached captures. How can I see in fortiOs 5.6 the status of each of phases 2?