Question
miglogd eating CPU
On my 300C, the miglogd process is sucking up 80%+ of my CPU processes, and causing the unit to peg out at 80%+ all the time. My memory seems fine at about 25%. When I issue the diag sys kill 11 [id-for-miglogd], it immediately shows up again (new process number, of course) running at 60% then 80%+. I have a call in to support, but thought I would ask here in case someone has seen this before. I tried turning off Event Logging, but that didn' t change anything. We are using the web-based reporting service (that is, not a local FortiAnalyzer). I have to reboot the the unit in order for the web GUI to come up (though, I' ve read that if I wait long enough, the gui should load). Any thoughts/ideas greatly appreciated. Specs: Host Name FG300C [Change] Serial Number FG300C Operation Mode NAT [Change] HA Status Standalone [Configure] System Time Mon May 14 14:21:18 2012 [Change] Firmware Version v4.0,build0521,120313 (MR3 Patch 6) [Update] [Details] System Configuration Last Backup: Mon May 7 11:30:19 2012 [Backup] [Restore] [Revisions] Current Administrator admin [Change Password] /1 in Total [Details] Uptime 0 day(s) 6 hour(s) 32 min(s) Virtual Domain Disabled [Enable]