Manual WAN1 configuration

Forum|Forum|1 year ago
November 19, 2024
2 replies
1415 views

Hello , could someone give me a light I'm configuring F60 , when the WAN1 card is set to receive DHCP modem from the operator it navigates normally , when I put it in Manual it stops navigating , I already went to the modem of the operator I made a DMZ I put the same IP Manual IP.jpg and nothing someone could help me with this

FortiGate

Best answer by Toshi_Esumi

Either the ISP modem/router change the subnet on the interface or you need to change the subnet on the DMZ. Changing the addressing method from DHCP to Manual wouldn't solve the problem.

Toshi

dingjerry_FTNT

Staff

Maybe you need to change your modem to Bridge mode? And did you create a static route for the default route?

Toshi_EsumiAnswer

SuperUser

Either the ISP modem/router change the subnet on the interface or you need to change the subnet on the DMZ. Changing the addressing method from DHCP to Manual wouldn't solve the problem.

Toshi

Marcos_FDS1012Author

New Member

Could you explain this better? I have another firewall the way I said there is no DMZ

dingjerry_FTNT

Staff

I think that you need to check it with your ISP first to see what IP you can use on your FGT. Your ISP will help you to configure your modem if needed.

Once you get the addressing info from your ISP, you can configure it on your FGT.

Sign up

Login with SSO

Login to the community

Login with SSO

Scanning file for viruses.

This file cannot be downloaded