Manage secondary firewall in HA pair independently of primary

Forum|Forum|3 years ago
February 23, 2023
3 replies
3497 views

We are configuring a two firewall HA pair using 2600-series and want to be able to log into each separately. This documentation appears to describe the configuration (https://docs.fortinet.com/document/fortigate/7.2.4/administration-guide/313152/out-of-band-management-with-reserved-management-interfaces), but when I go to System > HA > Primary Firewall, under the Management Interface Reservation, port17 isn't available to be selected, which is the management interface. It's on a different VRF than the other ports; however, I put another port into that particular VRF, and it shows up. I'm currently logged into the firewall using port17, so is that the problem? Could there be something else? Thank you.

FortiGate

Best answer by srajeswaran

Yes,need to remove the static route. You may configure the mgmt subnet route under HA settings under destination subnet.

Ref: https://community.fortinet.com/t5/FortiGate/Technical-Tip-HA-Reserved-Management-Interface/ta-p/190132

srajeswaran

Staff

Can you run "show | grep port17 -f", this will show if port17 is referenced in any other hierarchy other than "config system interface" and if it is referenced it cannot be configured as dedicated management interface.

albaker1Author

New Member

Thanks for your response srajeswaran. Does that include routes?

FTG2600 # show | grep port17 -f
config system interface
edit "port17" <---
set vdom "root"
set vrf 1
set ip 10.2.66.115 255.255.255.0
set allowaccess ping https ssh snmp fgfm
set type physical
set mediatype sr
set snmp-index 17
set speed 10000full
next
end
config router static
edit 67
set dst 172.16.0.0 255.255.0.0
set gateway 10.2.66.1
set device "port17" <---
next
edit 22
set dst 10.5.19.20 255.255.255.255
set gateway 10.2.66.1
set device "port17" <---
next
end