Skip to main content
vstefaneli
vstefaneli
New Member
November 21, 2017
Solved

Link-monitor specific route

  • November 21, 2017
  • 2 replies
  • 9910 views

Hello everyone!

 

Is there someway to attach a 'link-monitor' to a specific static route??

The feature "set update-static-route enable" just remove ALL the routes rellated to an interface.

 

I was looking for something like Cisco track, that you can attach to any static route.

 

Thanks in advance.

 

    Best answer by packetpusher

    In essence it is the same as the Cisco track feature. In either way you are monitoring a destination server.

    2 replies

    packetpusher
    packetpusherAnswer
    New Member
    November 22, 2017

    In essence it is the same as the Cisco track feature. In either way you are monitoring a destination server.

    vstefaneli
    vstefaneliAuthor
    New Member
    December 8, 2017

    Yes and not, I guess.

     

    Yes, it can monitor a destination IP... (with "link-monitor" on Fortigate, or "IP SLA" on Cisco)

     

    But with Cisco it could attach the "sla/track" individually on each route, but with Fortigate it just remove ALL the routes related to that interface.

     

    This is a problem cause Fortigate is acting as MPLS concentrator in my topology. I need to clear only the routes that are not answering to the "link-monitor" not all routes on that MPLS.

     

     

    SteveG
    SteveG
    New Member
    August 23, 2018

    Did you ever get an answer to this as I need to do the same thing, remove a single static rather than all statics associated with an interface?

    Terms & ConditionsAccessibility statement