Skip to main content
technician
technician
New Member
October 12, 2016
Question

link aggregation using port 15 and port 16

  • October 12, 2016
  • 1 reply
  • 18028 views

Hi, I was asked to cascade the port 16 or a Fortigate 200D to a Csico 2960-X L2 switch. Now my boss wants me to have a backup of port 15 in case port 16 goes down. So from ports 15 and 16 going to ports 23-24 of the Cisco 2960-X switch. I followed the following articles for me to link aggregate the 2 ports. 

http://kb.fortinet.com/kb/documentLink.do?externalID=FD30542

https://forum.fortinet.com/tm.aspx?m=106460

 

but in my cisco switch, it still shows that 

LACP is currently not enabled on remote ports. Am I imssing something here?

 

Thanks

Jeff

    1 reply

    Nils
    Nils
    New Member
    October 12, 2016

    Try to set the Fortigate as Active in LACP.

    Both can be configured as active.

    technician
    technicianAuthor
    New Member
    October 12, 2016

    I'm not sure if I get it right but I think based on the article Ive followed it was set in active, unless I've missed something or other commands needed

    Thanks

    Jeff

    hklb
    hklb
    Visitor III
    October 12, 2016

    Maybe with a copy of your interface configuration (fortinet and cisco), it will be easier to find this issue..

    Terms & ConditionsAccessibility statement