Skip to main content
kellerke
kellerke
New Member
February 27, 2018
Question

LAG between HP 5406 and Fortigate 1500D

  • February 27, 2018
  • 1 reply
  • 2498 views

I currently have my 1500D setup with three one gig connections going to my HP switch using LAN1, WAN1 and WAN2 with each of these using an IP address. I would like to create LAG ports so I can Increase the bandwidth and redundancy but I do not want to redo all my policy's and VIP's. Is it possible to create new LAG Ports with say LAN1 and LAN2 but having it listed as LAN1 still so the policies work and the same for WAN1 and WAN2 where I would LAG Wan1 with WAN3 and WAN2 with WAN4 but keep the ladled with WAN1 and WAN2 so that the policies and VIP's still work. I would use the same address on these LAG ports. Is this possible?

 

Thanks

Kevin

    1 reply

    kellerke
    kellerkeAuthor
    New Member
    February 28, 2018

    After reading my post again it should really be setting a LAG up for Port1 and Port2 and calling it LAN1 and keeping the policies and Port15 and Port17 as WAN1 and Port16 and Port18 as WAN2 but I need to keep all the VIP's and Policies, I hope this is a little clearer.

    Thanks

    Kevin 

    Terms & ConditionsAccessibility statement