Keep Dial Up VPN Tunnel up permanently

Forum|Forum|8 years ago
February 28, 2018
6 replies
18569 views

Hello folks,

I have the problem, that my remote-site does not use static-ip-adresses. So I can only use a dial-up-vpn-configuration. Some devices between the 2 VPN-endpoints are needing a permanent connection, but when no traffic goes over the tunnel, the tunnel will not "get up".

Is there a way, to keep the dial-up-tunnel up, although there is no traffic going over it? (keep it up permanently)

Markus

New Member

Hi,

Not sure if this is possible in Dialup VPN, maybe you can try to set keep alive enable in phase2 config vpn ipsec phase2-interface->edit *interface*->set keep alive enable Good Luck