Skip to main content
SaschaH
SaschaH
New Member
November 12, 2015
Question

IPv6 SLAAC not working FG60D FW5.2.4

  • November 12, 2015
  • 2 replies
  • 9493 views

Hello everybody,

 

i have a DS-lite cable-internet-connection and wanted my FG60D LAN1 to autoconfigure with SLAAC from my Fritz!Box.

I only have two options at the LAN1: Manual and DHCP.

When set to DHCP, i receive no IPv6 Information at all.

Where can i enable SLAAC-Option?

 

Regards

Sascha

    2 replies

    emnoc
    emnoc
    New Member
    November 12, 2015

    You need to relook it's under config ipv6

     

    set ip6-mode 

     

    You probable need to unset that value and than SLAAC will be enabled

    SaschaH
    SaschaHAuthor
    New Member
    November 12, 2015

    emnoc wrote:

    You need to relook it's under config ipv6

     

    set ip6-mode 

     

    You probable need to unset that value and than SLAAC will be enabled

    I just unset it, but that didn't help. No IPv6-address...

     

    For those who might ask - yes, other clients receive IPv6-addresses.

    emnoc
    emnoc
    New Member
    November 12, 2015

    And the other clients are SLAAC ( aka autoconfig ) enabled and not dhcpv6? Can you try a different port? It could be a bug in the  v5.2.4 ( I wouldn't be surprised if it is )

     

    Ken

     

    SaschaH
    SaschaHAuthor
    New Member
    November 12, 2015

    I tried all ports by now. And yes, the other clients are all SLAAC (tested with raspbian and debian without dhcpcd5). Anyway, even if the Fritz!Box where offering DHCPv6 in addition to RA, then it would be supposed to work too.

    emnoc
    emnoc
    New Member
    November 12, 2015

    Can you downgrade from 5.2.4 to 5.2.3 and give that a try? Once again  v5.2.4 has many problems, maybe SLAAC is one of them ;)

     

    Terms & ConditionsAccessibility statement